Souderton, PA HVAC Services You Can Count On

The core of the borough has brick twins and rowhouses with front porches and tight lots, many from the early 1900s boom. These houses have usually been through several heating systems, and the ductwork, if there is any, was often fitted into joist bays and plaster walls that were not built for it. A load calculation before we touch equipment avoids repeating an old sizing mistake.

Electrical service deserves a look in houses this age. Panels and circuits have often been upgraded piecemeal, and a heat pump air handler, a mini-split or even a modern blower motor may need more than the existing circuit can carry. We check the panel and coordinate with a licensed electrician when the load calls for it.

Gas comes from PECO and electricity from PPL, so many Souderton homes have both options, though a gas main does not run down every street. Venting is the other check: a chimney built for an older, hotter furnace can be oversized or damp-prone for a newer one, which is when a liner or direct vent is needed.

Before a heat pump or mini-split install in an older Souderton house, we open the panel and read the breaker size, look at the wire gauge and note how many circuits are in use. If the circuit is not right for the equipment, we say so up front and plan the electrical work first.

On a furnace swap, we check where the old flue went, whether the liner is intact and whether the new unit's vent fits the existing chimney. A vent that was fine for the old furnace can leave condensate in the masonry when a higher-efficiency unit is connected to it.

We run a carbon monoxide check when we service an older gas or oil appliance, especially if the home changed hands recently and has no service record. It takes a few minutes with the burner running and shows whether combustion gases are venting properly.