HVAC Services in the Licking Run Corridor

Below-grade equipment is the defining risk. Controls, gas valves and electrical parts bolted near a basement floor are the first things water damages. Raising equipment on a rated stand and keeping condensate and sump discharge working are practical steps; whether they make sense depends on your basement and its history.

After any flooding, heating equipment that was submerged or splashed needs a professional inspection before it runs again. Gas valves, controls and electrical parts are commonly replaced after water exposure. If water is around an energized unit, don't touch it; shut off power at the breaker only if you can reach it safely, and call a qualified technician.

Humidity is the other half. Damp basements push moisture into the whole house, and an air conditioner removes some of it, but a dehumidifier is separate equipment and sump reliability matters as much as the HVAC. We'll tell you whether the problem is the equipment or the water.

On a visit to a basement with a wet history we look at equipment height above the floor and drain, rust lines on the cabinet, the condition of the gas valve and controls, and whether the flue and combustion air are intact.

We trace the condensate drain to where it discharges, a floor drain or a pump, then check the sump setup and ask whether a pump failure or power cut would put water at the equipment.

On oil systems we check how the tank is supported and anchored, since tanks can shift in a flood, and we look at the fill and vent lines for damage or leaks.